Assembly guide
You can attach the wall mount in two ways: with tape or with screws. Both routes are described step by step below.
Taping
Peel the backing off the 3M™ tape on the rear.
- Choose your spot carefully – mind the height.
- Keep the bonding area free of moisture.
- the wall should ideally be dry and even
Press the mount on firmly for 30 seconds with the flat of your hand.
Let the adhesive cure for 12 hours, without hanging the body or any other weight on the mount.
Following these rules is essential for a permanent hold on the wall.
Removing the mount again
Turn the mount along the wall surface, alternating the direction of rotation. Once removed, the adhesive cannot be reused – reattaching is only possible with a fresh adhesive strip. Alternatively you can screw the mount on.
Screwing
Push the silicone BoTrik logo out from the back through the matching openings.
- For masonry walls:
- use the mount as a template.
- mark 2 points.
- use a detector to check that no electrical cables, gas or water pipes run in the wall at these points.
- drill 2 holes.
- insert 2 wall plugs.
Fasten the mount with 2 countersunk screws.
- Thread the logo back into place.
- use the flexibility of the silicone logo
Please note:
Plugs and screws are not included.
Hand-tight only, the mount is made of plastic.